DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
204
DGS-3000-26TC:admin#debug show status module MSTP
Command: debug show status module MSTP
Debug Global State : Enabled
MSTP : Disabled
To show the debug state:
DGS-3000-26TC:admin#debug show status
Command: debug show status
Debug Global State : Enabled
MSTP : Disabled
IMPB : Disabled
DHCPv6_RELAY : Disabled
DHCPv6_SERVER : Disabled
debug dhcpv6_relay hop_count state 18-8
Description
This command is used to enable or disable debug information flag about the hop count.
Format
debug dhcpv6_relay hop_count state [enable | disable]
Parameters
enable - Specify that the hop count state will be enabled.
disable - Specify that the hop count state will be disabled.
Restrictions
Only Administrators can issue this command.
Example
To enable debug information flag about the hop count:
To Next Page
Loading...
