DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
205
DGS-3000-26TC:admin# debug dhcpv6_relay hop_count state enable
Command: debug dhcpv6_relay hop_count state enable
Success.
debug dhcpv6_relay output 18-9
Description
This command is used to set debug message to output to buffer or console.
Format
debug dhcpv6_relay output [buffer | console]
Parameters
buffer - Let the debug message output to buffer.
console - Let the debug message output to console.
Restrictions
Only Administrators can issue this command.
Example
To set debug information to output to console:
DGS-3000-26TC:admin# debug dhcpv6_relay output console
Command: debug dhcpv6_relay output console
Success.
debug dhcpv6_relay packet 18-10
Description
This command is used to enable or disable debug information flag for DHCPv6 relay packet,
including packet receiving and sending.
Format
debug dhcpv6_relay packet [all | receiving | sending] state [enable | disable]
Parameters
all - Set packet receiving and sending debug flags.
receiving - Set packet receiving debug flag.
To Next Page
Loading...
