DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
206
sending - Set packet sending debug flag.
state - Specify if the designated flags function will be enabled or disabled.
enable - Enable the designated flags.
disable - Disable the designated flags.
Restrictions
Only Administrators can issue this command.
Example
To enabled DHCPv6 relay packet sending debug:
DGS-3000-26TC:admin# debug dhcpv6_relay packet sending state enable
Command: debug dhcpv6_relay packet sending state enable
Success.
debug dhcpv6_relay state disable 18-11
Description
This command is used to disable the DHCPv6 relay Debug function.
Format
debug dhcpv6_relay state disable
Parameters
None.
Restrictions
Only Administrators can issue this command.
Example
To disabled DHCPv6 relay debug function:
DGS-3000-26TC:admin# debug dhcpv6_relay state disable
Command: debug dhcpv6_relay state disable
Success.
To Next Page
Loading...
