D-Link DGS-3000 - Page 211

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
207
debug dhcpv6_relay state enable 18-12
Description
This command is used to enable the DHCPv6 relay Debug function.
Format
debug dhcpv6_relay state enable
Parameters
None.
Restrictions
Only Administrators can issue this command.
Example
To enabled DHCPv6 relay debug function:
DGS-3000-26TC:admin# debug dhcpv6_relay state enable
Command: debug dhcpv6_relay state enable
Success.
DGS-3000-26TC:admin#
debug dhcpv6_server packet 18-13
Description
This command is used to enable or disable the debug information flag of the DHCPv6 server
packet, including packets receiving and sending.
Format
debug dhcpv6_server packet [all | receiving | sending] state [enable | disable]
Parameters
all - Set packet receiving and sending debug flags.
receiving - Set packet receiving debug flag.
sending - Set packet sending debug flag.
state - Specify the state of the designated flags.
enable - Enable the designated flags.
disable - Disable the designated flags.
Restrictions
Only Administrators can issue this command.