D-Link DGS-3000

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
675
disable qinq 68-2
Description
This command is used to disable the QinQ. When QinQ is disabled, all dynamic learned L2
addresses will be cleared, all dynamic registered VLAN entries will be cleared, and GVRP will be
disabled. To run GVRP on the Switch, the administrator should enable GVRP manually.
Format
disable qinq
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To disable QinQ:
DGS-3000-26TC:admin#disable qinq
Command: disable qinq
Success.
DGS-3000-26TC:admin#
config qinq inner_tpid 68-3
Description
This command is used to configure the inner TPID of the system. The inner TPID is used to decide
if the ingress packet is c-tagged. Inner tag TPID is per system configurable.
Format
config qinq inner_tpid <hex 0x1-0xffff>
Parameters
<hex 0x1-0xffff> - Enter the inner-TPID of the system here.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.