DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
491
DGS-3000-26TC:admin#config lldp ports 1-5 notification enable
Command: config lldp ports 1-5 notification enable
Success.
To configure port 1-5 to transmit and receive:
DGS-3000-26TC:admin#config lldp ports 1-5 admin_status tx_and_rx
Command: config lldp ports 1-5 admin_status tx_and_rx
Success.
To enable ports 1-2 for manage address entry:
DGS-3000-26TC:admin#config lldp ports 1-2 mgt_addr ipv4 10.90.90.90 enable
Command: config lldp ports 1-2 mgt_addr ipv4 10.90.90.90 enable
Success.
To configure exclude the system name TLV from the outbound LLDP advertisements for all ports:
DGS-3000-26TC:admin#config lldp ports all basic_tlvs system_name enable
Command: config lldp ports all basic_tlvs system_name enable
Success.
To configure exclude the vlan nameTLV from the outbound LLDP advertisements for all ports:
DGS-3000-26TC:admin#config lldp ports all dot1_tlv_pvid enable
Command: config lldp ports all dot1_tlv_pvid enable
Success.
To configure exclude the port and protocol VLAN ID TLV from the outbound LLDP advertisements
for all ports:
To Next Page
Loading...
