D-Link DGS-3000 - Page 498

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
494
DGS-3000-26TC:admin#show lldp
Command: show lldp
LLDP System Information
Chassis ID Subtype : MAC Address
Chassis ID : 00-01-02-03-04-00
System Name :
System Description : Gigabit Ethernet Switch
System Capabilities : Repeater, Bridge
LLDP Configurations
LLDP Status : Enabled
LLDP Forward Status : Enabled
Message TX Interval : 30
Message TX Hold Multiplier: 4
ReInit Delay : 2
TX Delay : 2
Notification Interval : 5
DGS-3000-26TC:admin#
show lldp mgt_addr 46-8
Description
This command is used to display the LLDP management address information.
Format
show lldp mgt_addr {[ipv4 <ipaddr> | ipv6 <ipv6addr>]}
Parameters
ipv4 - (Optional) Specify the IPv4 address used for the display.
<ipaddr> - Enter the IPv4 address used for this configuration here.
ipv6 - (Optional) Specify the IPv6 address used for the display.
<ipv6addr> - Enter the IPv6 address used for this configuration here.
Restrictions
None.
Example
To display management address information: