D-Link DGS-3000 - Page 204

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
200
Format
debug buffer [utilization | dump | clear | upload_toTFTP <ipaddr> <path_filename 64>]
Parameters
utilization - Displays the debug buffer’s state.
dump - Displays the debug message in the debug buffer.
clear - Clears the debug buffer.
upload_toTFTP - Specify to upload the debug buffer to a TFTP server specified by IP address.
<ipaddr> - Enter the IPv4 address of the TFTP server.
<path_filename 64> - Enter the DOS pathname on the TFTP server. It can be a relative
pathname or an absolute pathname. This value can be up to 64 characters long.
Restrictions
Only Administrator users can issue this command.
Example
To show the debug buffer’s state:
DGS-3000-26TC:admin#debug buffer utilization
Command: debug buffer utilization
Allocate from : System memory pool
Total size : 2 MB
Utilization rate : 30%
DGS-3000-26TC:admin#
To clear the debug buffer:
DGS-3000-26TC:admin#debug buffer clear
Command: debug buffer clear
Success.
DGS-3000-26TC:admin#
To upload the messages stored in debug buffer to TFTP server:
DGS-3000-26TC:admin#debug buffer upload_toTFTP 10.0.0.90 debugcontent.txt
Command: debug buffer upload_toTFTP 10.0.0.90 debugcontent.txt
Connecting to server................... Done.
Upload debug file ................... Done.
DGS-3000-26TC:admin#