DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
212
d. Sub-option’s length, it should be 4
e. VLAN ID (S-VID)
f. Module ID, for standalone switch, it is 0; for stacking switch, it is the box ID that
assigned by stacking.
g. Port ID: port number of each box.
vendor1 - If configured to vendor1, the circuit ID uses the following format to communicate with
a. Sub-option type (1 means circuit ID).
b. Length.
c. Circuit ID’s sub-option’s first tag, it should be 0.
d. First tag’s length, it should be 6.
e. VLAN ID.
f. Slot ID, for standalone switch, it is 1; for stacking switch, it is the box ID that
assigned by stacking.
g. Port ID: port number of each box.
h. Circuit ID’s sub-option’s second tag, it should be 1.
i. Second tag’s length, it should be 6.
j. MAC address: System’s MAC address.
vendor6 - If configured to vendor6, the cicuit ID uses the following:
F01: Sub-option type (1 means circuit ID).
F02: Length.
F03: Character ‘E’.
F04: Character ‘t’.
F05: Character ‘h’.
F06: Character ‘e’.
F07: Character ‘r’.
F08: Character ‘n’.
F09: Character ‘e’.
F10: Character ‘t’.
F11: Chassis ID. The number of the chassis. For stand-alone devices, the chassis ID
will always be 1. For stacked devices, the chassis ID will be the unit ID.
To Next Page
Loading...
