DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
289
config dhcpv6_relay ipif 23-7
Description
This command is used to configure the DHCPv6 relay state of one specific interface or all
interfaces.
Format
config dhcpv6_relay ipif [<ipif_name 12> | all] state [enable | disable]
Parameters
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12 characters
long.
all - Specify that all the configured IP interfaces wil be used.
state - Specify if the DHCPv6 relay state will be enabled or disabled.
enable - Choose this parameter to enable the DHCPv6 relay state of the interface.
disable - Choose this parameter to disable the DHCPv6 relay state of the interface.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the DHCPv6 relay state of the System interface to enable:
DGS-3000-26TC:admin# config dhcpv6_relay ipif System state enable
Command: config dhcpv6_relay ipif System state enable
Success.
config dhcpv6_local_relay vlan 23-8
Description
This command is used to enable or disable the DHCPv6 local relay function for a specified VLAN.
Format
config dhcpv6_local_relay vlan [<vlan_name 32> |vlanid <vlan_id>] state [enable | disable]
Parameters
<vlan_name 32> - Enter the VLAN name that will be used for this configuration
vlanid - Specify the VLAN ID that will be used for this configuration. It supports up to 48 VLANs.
<vlan_id> - Enter the VLAN ID that will be used for this configuration. It supports up to 48
state - Specify the DHCPv6 local relay function's state for the specified VLAN.
enable - Specify to enable the DHCPv6 local relay function's state for the specified VLAN.
To Next Page
Loading...
