D-Link DGS-3000 - Page 383

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
379
Parameters
enable - Enables the learning of ARP entry based on the received gratuitous ARP packet. This is
the default value.
disable - Disables the learning of ARP entry based on the received gratuitous ARP packet.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To show the global GratuitousARP state:
DGS-3000-26TC:admin#config gratuitous_arp learning enable
Command: config gratuitous_arp learning enable
Success.
DGS-3000-26TC:admin#
config gratuitous_arp send periodically 36-4
Description
This command is used to configure the interval for the periodical sending of gratuitous ARP
request packet. By default, the interval is 0.
Format
config gratuitous_arp send periodically ipif <ipif_name 12> interval <value 0-65535>
Parameters
ipif - Specify the interface name of L3 interface.
<ipif_name 12> - Enter the IP interface name here. This name can be up to 12 characters
long.
interval - Specify the periodically sending gratuitous ARP interval time in seconds. 0 means not
to send gratuitous ARP periodically.
<value 0-65535> - Enter the gratuitous ARP interval time here. This value must be between 0
and 65535 seconds.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure gratuitous ARP interval to 5 for IPIF System: