D-Link DGS-3000 - Page 393

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
389
clear igmp_snooping statistics counter
show igmp_snooping host {[vlan <vlan_name 32> | vlanid <vlanid_list> | ports <portlist> | group
<ipaddr>]}
config igmp_snooping 38-1
Description
This command is used to configure IGMP snooping on the Switch.
Format
config igmp_snooping [vlan_name <vlan_name 32> | vlanid <vlanid_list> | all ] {state
[enable | disable] | fast_leave [enable | disable] | report_suppression [enable | disable] |
proxy_reporting {state [enable | disable] | source_ip <ipaddr>}(1)}(1)
Parameters
vlan_name - Specify the name of the VLAN for which IGMP snooping is to be configured.
<vlan_name 32> - Enter the VLAN name here. The VLAN name can be up to 32 characters
long.
vlanid - Specify the VLAN ID for which IGMP snooping is to be configured.
<vlanid_list> - Enter the VLAN ID here.
all - Specify to use all configured VLANs.
state - (Optional) Specify to enable or disable IGMP snooping for the chosen VLAN.
enable - Specify to enable IGMP snooping for the chosen VLAN.
disable - Specify to disable IGMP snooping for the chosen VLAN.
fast_leave - Specify to enable or disable the IGMP snooping fast leave function.
enable - Specify to enable the IGMP snooping fast leave function. If enabled, the membership
is immediately removed when the system receives the IGMP leave message.
disable - Specify to disable the IGMP snooping fast leave function.
report_suppression - Specify whether to use IGMP report suppression to forward only one
IGMP report per multicast router query to multicast devices.
enable - Specify to use IGMP report suppression to forward only one IGMP report per
multicast router query to multicast devices.
disable - Disables IGMP report suppression to forward only one IGMP report per multicast
router query to multicast devices.
proxy reporting - Specify IGMP proxy reporting. If enabled, multiple IGMP reports or leave for a
specific (S, G) will be integrated into one report only before sending to the router port.
state - Specify to enable or disable the proxy reporting.
enable - Specify to enable the proxy reporting.
disable - Specify to disable the proxy reporting.
source_ip - Specify the source IP of proxy reporting integrated report. Default value is zero
IP.
<ipaddr> - Enter the IP address.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure IGMP snooping: