D-Link DGS-3000 - Page 417

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
413
DGS-3000-26TC:admin#clear igmp_snooping statistic counter
Command: clear igmp_snooping statistic counter
Success.
DGS-3000-26TC:admin#
show igmp_snooping host 38-24
Description
This command is used to display the IGMP hosts that have joined groups on specific ports or
specific VLANs.
Format
show igmp_snooping host {[vlan <vlan_name 32> | vlanid <vlanid_list> | ports <portlist> |
group <ipaddr>]}
Parameters
vlan - (Optional) Specify the VLAN name.
<vlan_name 32> - Enter the VLAN name here. This name can be up to 32 characters long.
vlanid - (Optional) Specify the VLAN ID.
<vlanid_list> - Enter the VLAN ID here.
ports - (Optional) Specify that list of port that will be displayed.
<portlist> - Enter the list of ports here.
group - (Optional) Specify the group.
<ipaddr> - Enter the group IP address here.
If no parameter is specified, all joining hosts will be displayed.
Restrictions
None.
Example
To display the host IP information: