DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
429
Parameters
ports - Specify the list of ports you would like to set the maximum number of entries that can be
learned.
<portlist> - Enter the list of ports used here.
all - Specify that all the ports will be used.
limit - Specify the maximum number. The default value is no_limit.
<value 1-50> - Enter the limit value here. This value must be between 1 and 50.
no_limit - Specify that the maximum number of learned entries is unlimited.
ipv6 - (Optional) Specify the IPv6 address used for this configuration.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To set the maximum number of DHCP IPv4 snooping entries that ports 1–3 can learned to 10:
DGS-3000-26TC:admin#config address_binding dhcp_snoop max_entry ports 1-3 limit
10.
Command: config address_binding dhcp_snoop max_entry ports 1-3 limit 10.
Success.
enable address_binding nd_snoop 39-17
Description
This command is used to enable ND snooping on the Switch.
Format
enable address_binding nd_snoop
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable the ND snooping function on the switch:
To Next Page