D-Link DGS-3000 - Page 464

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
460
port_based - Specify the port authentication mode as port-based.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the JWAC port state:
DGS-3000-26TC:admin#config jwac ports 1-9 state enable
Command: config jwac ports 1-9 state enable
Success.
DGS-3000-26TC:admin#
show jwac ports 42-19
Description
This command is used to display the port configuration of JWAC.
Format
show jwac ports {<portlist>}
Parameters
<portlist> - (Optional) Enter a port range to show the configuration of JWAC.
Restrictions
None.
Example
To display JWAC ports 1 to 4: