DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
476
threshold - (Optional) Specify the drop threshold for packets-per-second accepted on the
UNI ports. The ports drop the PDU if the protocol’s threshold is exceeded.
<value 0-65535> - Enter the threshold range value between 0 to 65535
(packet/second). 0 means no limit. By default, the value is 0.
nni - Specify the ports as NNI ports.
none - Disables tunnel on it.
Restrictions
Only Administrators and Operators can issue this command.
Example
To configure the STP tunneling on ports 1-4:
DGS-3000-26TC:admin#config l2protocol_tunnel ports 1-4 type uni
tunneled_protocol stp
Command: config l2protocol_tunnel ports 1-4 type uni tunneled_protocol stp
Success.
show l2protocol_tunnel 44-4
Description
This command is used to display Layer 2 protocol tunneling information.
Format
show l2protocol_tunnel {[uni | nni]}
Parameters
uni - (Optional) Specify to show UNI detail information, include tunneled and dropped PDU
statistic.
nni - (Optional) Specify to show NNI detail information, include de-capsulated Layer 2 PDU
statistic.
Restrictions
None.
Example
To show Layer 2 protocol tunneling information summary:
To Next Page
Loading...
