D-Link DGS-3000 - Page 510

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
506
DGS-3000-26TC:admin#config lldp_med ports all med_transmit_capabilities all
state enable
Command: config lldp_med ports all med_transmit_capabilities all state enable
Success.
DGS-3000-26TC:admin#
show lldp_med ports 46-18
Description
This command is used to display LLDP-MED per port configuration for advertisement options.
Format
show lldp_med ports {<portlist>}
Parameters
<portlist> - (Optional) Enter a range of ports to be displayed.
If a port list is not specified, information for all ports will be displayed.
Restrictions
None.
Example
To display LLDP-MED configuration information for port 1:
DGS-3000-26TC:admin#show lldp_med ports 1
Command: show lldp_med ports 1
Port ID : 1
-----------------------------------------------------------------
Topology Change Notification Status :Enabled
LLDP-MED Capabilities TLV :Enabled
LLDP-MED Network Policy TLV :Enabled
LLDP-MED Extended Power Via MDI PSE TLV :Enabled
LLDP-MED Inventory TLV :Enabled
DGS-3000-26TC:admin#
show lldp_med 46-19
Description
This command is used to display the Switch’s general LLDP-MED configuration status.