D-Link DGS-3000 - Page 528

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
524
Format
config mac_based_access_control password <passwd 16>
Parameters
password - In RADIUS mode, the Switch will communicate with the RADIUS server using this
password. The maximum length of the key is 16.
<passwd 16> - Enter the password used here. The default password is “default”.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To set the MAC-based Access Control password:
DGS-3000-26TC:admin#config mac_based_access_control password switch
Command: config mac_based_access_control password switch
Success.
DGS-3000-26TC:admin#
config mac_based_access_control password_type 49-4
Description
This command is used to chose the password type used for authentication via the RADIUS server.
Format
config mac_based_access_control password_type [manual_string | client_mac_address]
Parameters
manual_string - Use the same password for all clients to communicate with the RADIUS server.
client_mac_address - Use the client’s MAC address as the password to communicate with the
RADIUS server.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the MAC-based Access Control using client’s MAC address as authentication
password: