D-Link DGS-3000 - Page 533

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
529
Format
delete mac_based_access_control [guest_vlan <vlan_name 32> | guest_vlanid <vlanid 1-
4094>]
Parameters
guest_vlan - Specify the name of the MAC-based Access Control’s guest VLAN.
<vlan_name 32> - Enter the VLAN name here. This name can be up to 32 characters long.
guest_vlanid - Specify the VID of the MAC-based Access Control’s guest VLAN.
<vlanid 1-4094> - Enter the VLAN ID here. This value must be between 1 and 4094.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To delete the MAC-based Access Control guest VLAN called default:
DGS-3000-26TC:admin#delete mac_based_access_control guest_vlan default
Command: delete mac_based_access_control guest_vlan default
Success.
DGS-3000-26TC:admin#
clear mac_based_access_control auth_state 49-10
Description
This command is used to clear the authentication state of a user (or port). The port (or the user)
will return to an un-authenticated state. All the timers associated with the port (or the user) will be
reset.
Format
clear mac_based_access_control auth_state [ports [all | <portlist>] | mac_addr <macaddr>]
Parameters
ports - Specify the port range to delete MAC addresses on them.
all - Specify to delete the MAC addresses of all MAC-based Access Control enabled ports.
<portlist> - Enter the list of port used for this configuration here.
mac_addr - Specify to delete a specified host with this MAC address.
<macaddr> - Enter the MAC address used here.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.