DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
562
<vlan_name> - Enter the VLAN name here.
vlanid - Specify the VLAN ID.
<vlanid_list> - Enter the VLAN ID list here.
<ipv6addr> - Enter the group’s IP address learned by data driven.
all - Specify to clear all data driven groups of the specified VLAN.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To clear all the groups learned by data-driven:
DGS-3000-26TC:admin#clear mld_snooping data_driven_group all
Command: clear mld_snooping data_driven_group all
Success.
show mld_snooping statistic counter 52-18
Description
This command is used to display the statistics counter for MLD protocol packets that are received
by the Switch since MLD snooping was enabled.
Format
show mld_snooping statistic counter [vlan <vlan_name> | vlanid <vlanid_list> | ports
<portlist>]
Parameters
vlan - Specify a VLAN to be displayed.
<vlan_name> - Enter the VLAN name here.
vlanid - Specify a list of VLANs to be displayed.
<vlanid_list> - Enter the VLAN ID list here.
ports - Specify a list of ports to be displayed.
<portlist> - Enter the list of port here.
Restrictions
None.
Example
To show MLD snooping statistics counters:
To Next Page