DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
580
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the maximum number of multicast group that ports 1 and 3 can join to 100:
DGS-3000-26TC:admin#config max_mcast_group ports 1, 3 max_group 100
Command: config max_mcast_group ports 1, 3 max_group 100
Success.
show max_mcast_group 54-8
Description
This command is used to display the maximum number of multicast groups that a port can join. If
the IPv4 or IPv6 option is not specified, IPv4 is implied.
Format
show max_mcast_group [ports <portlist> | vlanid <vlanid_list>] {[ipv4 | ipv6]}
Parameters
ports - Specify the range of ports for displaying information about the maximum number of
multicast groups that the specified ports can join.
<portlist> - Enter the list of ports to be configured here.
vlanid - Specify the VLAN ID for displaying the maximum number of multicast groups.
<vlanid_list> - Enter the VLAN ID list here.
ipv4 - (Optional) Specify to display the maximum number of IPv4 learned addresses.
ipv6 - (Optional) Specify to display the maximum number of IPv6 learned addresses.
Restrictions
None.
Example
To display the maximum number of multicast groups that ports 1 and 2 can join:
To Next Page
Loading...
