D-Link DGS-3000 - Page 586

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
582
Restrictions
None.
Example
To show the limited multicast address range on ports 1 and 3:
DGS-3000-26TC:admin#show limited_multicast_addr ports 1,3
Command: show limited_multicast_addr ports 1,3
Port : 1
Access : Deny
Profile ID Name Multicast Addresses
---------- -------------------------------- -------------------------------
2 MOD 225.1.1.1-225.1.1.10
Port : 3
Access : Permit
Profile ID Name Multicast Addresses
---------- -------------------------------- -------------------------------
2 MOD 225.1.1.1-225.1.1.10
DGS-3000-26TC:admin#
To show the limited multicast settings configured on VLAN 1:
DGS-3000-26TC:admin#show limited_multicast_addr vlan 1
Command: show limited_multicast_addr vlanid 1
VLAN ID : 1
Access : Permit
Profile ID Name Multicast Addresses
---------- -------------------------------- -------------------------------
2 MOD 225.1.1.1-225.1.1.10
DGS-3000-26TC:admin#
config cpu_filter l3_control_pkt 54-10
Description
This command is used to configure the port state for the Layer 3 control packet filter.