DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
654
Restrictions
None.
Example
To show all the port security entries:
DGS-3000-26TC:admin#show port_security_entry
Command: show port_security_entry
MAC Address VID Port Lock Mode
----------------- ---- ----- ---------------
00-00-00-00-00-01 1 25 DeleteOnTimeout
Total Entries: 1
show port_security 64-7
Description
This command is used to display the port security related information, including state, maximum
learned addresses and lock address mode on a port and/or on a VLAN.
If both ports and vlanid (or vlan_name) are specified, configurations matching any of these
parameters will be displayed.
Format
show port_sec
urity {ports {<portlist>}
{[vlan <vlan_na
me
32> | vlani
d
<vidlist>]}}
Parameters
ports - (Optional) Specify the range of ports that will show their configuration. While this
parameter is null, to show the entries on all of the ports.
<portlist> - Enter the list of port used for this configuration here.
vlan - (Optional) Specify the name of the VLAN that will show its configuration.
<vlan_name 32> - Enter the VLAN name here. This name can be up to 32 characters long.
vlanid - (Optional) Specify the ID of the VLAN that will show its configuration.
<vidlist> - Enter the VLAN ID list here.
Restrictions
None.
Example
To display the global configuration of port security:
To Next Page
Loading...
