D-Link DGS-3000 - Page 709

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
705
Parameters
None.
Restrictions
None.
Example
To display authentication client information:
DGS-3000-26TC:admin#show auth_client
Command: show auth_client
radiusAuthClient ==>
radiusAuthClientInvalidServerAddresses 0
radiusAuthClientIdentifier
radiusAuthServerEntry ==>
radiusAuthServerIndex :1
radiusAuthServerAddress 0.0.0.0
radiusAuthClientServerPortNumber 0
radiusAuthClientRoundTripTime 0
radiusAuthClientAccessRequests 0
radiusAuthClientAccessRetransmissions 0
radiusAuthClientAccessAccepts 0
radiusAuthClientAccessRejects 0
radiusAuthClientAccessChallenges 0
radiusAuthClientMalformedAccessResponses 0
radiusAuthClientBadAuthenticators 0
radiusAuthClientPendingRequests 0
radiusAuthClientTimeouts 0
radiusAuthClientUnknownTypes 0
radiusAuthClientPacketsDropped 0
DGS-3000-26TC:admin#
show acct_client 70-6
Description
This command is used to display information of RADIUS accounting client.
Format
show acct_client