D-Link DGS-3000 - Page 747

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
743
Format
disable smtp
Parameters
None.
Restrictions
Only Administrators can issue this command.
Example
To disable SMTP status:
DGS-3000-26TC:admin#disable smtp
Command: disable smtp
Success.
DGS-3000-26TC:admin#
config smtp 77-3
Description
This command is used to configure SMTP client parameters.
Format
config smtp {server <ipaddr> | server_port <tcp_port_number 1-65535> | self_mail_addr
<mail_addr 64> | [add mail_receiver <mail_addr 64> | delete mail_receiver <index 1-8>] |
server_ipv6 <ipv6addr> | server_port_ipv6 <tcp_port_number 1-65535>}(1)
Parameters
server - Specify the SMTP server IP address.
<ipaddr> - Enter the SMTP server IP address
server_port - Specify the SMTP server port.
<tcp_port_number 1-65535> - Enter the port number between 1 and 65535.
self_mail_addr - Specify the sender’s mail address.
<mail_addr 64> - Enter the mail address with maximum of 64 characters.
add mail_receiver - Specify to add mail receiver’s address.
<mail_addr 64> - Enter the mail address with maximum of 64 characters.
delete mail_receiver - Specify to delete mail receiver’s address.
<index 1-8> - Enter the index number.
server_ipv6 - Specify the SMTP server IPv6 address.
<ipv6addr> - Enter the IPv6 server IP address.
server_port_ipv6 - Specify the SMTP IPv6 server’s TCP port.
<tcp_port_number 1-65535> - Enter the TCP port number.