DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
71
create authen server_group 5-18
Description
This command is used to create a user-defined authentication server group. The maximum
supported number of server groups including built-in server groups is 8. Each group consists of 8
server hosts as maximum.
Format
create authen server_group <string 15>
Parameters
<string 15> - Enter the user-defined server group name. This value can be up to 15 characters
long.
Restrictions
Only Administrators can issue this command.
Example
To create a user-defined authentication server group:
DGS-3000-26TC:admin#create authen server_group mix_1
Command: create authen server_group mix_1
Success.
config authen server_group 5-19
Description
This command is used to add or remove an authentication server host to or from the specified
server group. Built-in server group “TACACS”, “XTACACS”, “TACACS+”, “RADIUS” accepts the
server host with the same protocol only, but user-defined server group can accept server hosts
with different protocols.
Format
config authen server_group [tacacs | xtacacs | tacacs+ | radius | <string 15>] [add | delete]
server_host [<ipaddr> | ipv6 <ipv6addr> ] protocol [tacacs | xtacacs | tacacs+ | radius]
Parameters
tacacs - Built-in server group “TACACS”.
xtacacs - Built-in server group “XTACACS”.
tacacs+ - Built-in server group “TACACS+”.
radius - Built-in server group “RADIUS”.
<string 15> - Enter the server group name here. This value can be up to 15 characters long.
To Next Page
Loading...
