D-Link DGS-3000 - Page 753

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
749
show rmon
enable community_encryption 78-1
Description
This command is used to enable the encryption state on the SNMP community string.
Format
enable community_encryption
Parameters
None.
Restrictions
Only Administrators can issue this command.
Example
To enable the encryption state on an SNMP community string:
DGS-3000-26TC:admin# enable community_encryption
Command: enable community_encryption
Success.
DGS-3000-26TC:admin#
disable community_encryption 78-2
Description
This command is used to disable the encryption state on the SNMP community string.
Format
disable community_encryption
Parameters
None.
Restrictions
Only Administrators can issue this command.