D-Link DGS-3000 - Page 792

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
788
To change the time interval of discovery protocol:
DGS-3000-26TC:admin#config sim dp_interval 30
Command: config sim dp_interval 30
Success.
DGS-3000-26TC:admin#
To change the hold time of discovery protocol:
DGS-3000-26TC:admin#config sim hold_time 200
Command: config sim hold_time 200
Success.
DGS-3000-26TC:admin#
download sim_ms 80-7
Description
This command is used to download firmware or configuration from TFTP server to indicated
devices.
Format
download sim_ms [firmware_from_tftp | configuration_from_tftp] {[<ipaddr> | <ipv6addr>]
<path_filename> {[members <mslist 1-32> | all]}}
Parameters
firmware_from_tftp - Specify to download firmware from a TFTP server.
configuration_from_tftp - Specify to download configuration from a TFTP server.
<ipaddr> - (Optional) Enter the IP address of the TFTP server.
<ipv6addr> - (Optional) Enter the IPv6 address of TFTP server.
<path_filename> - (Optional) Enter the file path of firmware or configuration in the TFTP server.
members - (Optional) Specify a range of members which download this firmware or
configuration.
<mslist 1-32> - Enter a range of members which download this firmware or configuration.
all - (Optional) Specify all members which download this firmware or configuration.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To download firmware: