D-Link DGS-3000 - Page 803

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
799
DGS-3000-26TC:admin#config syslog source_ipif none
Command: config syslog source_ipif none
Success
DGS-3000-26TC:admin#
show syslog source_ipif 82-2
Description
This command is used to display the syslog source IP interface.
Format
show syslog source_ipif
Parameters
None.
Restrictions
None.
Example
Show syslog source IP interface:
DGS-3000-26TC:admin#show syslog source_ipif
Command: show syslog source_ipif
Syslog Source IP Interface Configuration:
IP Interface : ipif3
IPv4 Address : 14.0.0.5
IPv6 Address : None
DGS-3000-26TC:admin#
config trap source_ipif 82-3
Description
This command is used to configure trap source IP interface.
Format
config trap source_ipif [<ipif_name 12> {<ipaddr> | <ipv6addr> } | none]