DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
808
Format
config syslog host [<index> | all] {severity [emergency | alert | critical | error | warning |
notice | informational | debug| <level 0-7>] | facility [local0 | local1 | local2 | local3 | local4 |
local5 | local6 | local7] | udp_port <udp_port_number> | ipaddress [<ipaddr> | <ipv6addr>] |
state [enable | disable]}(1)
Parameters
<index> - Enter the host index value here.
all - Specify that all the host indexes will be used.
severity - Specify the severity level.
emergency - Severity level 0.
alert - Severity level 1.
critical - Severity level 2.
error - Severity level 3.
warning - Severity level 4.
notice - Severity level 5.
informational - Severity level 6.
debug - Severity level 7.
<level 0-7> - Enter the severity level value here. This value must be between 0 and 7.
facility - Some of the operating system daemons and processes have been assigned Facility
values. Processes and daemons that have not been explicitly assigned a Facility may use any
of the "local use" facilities or they may use the "user-level" Facility. Those Facilities that have
been designated are shown below. This facility setting will be put in the syslog packet when it
is sent to a specific syslog server.
local0 - Specify that the user-defined facility will be set to local 0.
local1 - Specify that the user-defined facility will be set to local 1.
local2 - Specify that the user-defined facility will be set to local 2.
local3 - Specify that the user-defined facility will be set to local 3.
local4 - Specify that the user-defined facility will be set to local 4.
local5 - Specify that the user-defined facility will be set to local 5.
local6 - Specify that the user-defined facility will be set to local 6.
local7 - Specify that the user-defined facility will be set to local 7.
udp_port - Specify the UDP port number.
<udp_port_number> - Enter the UDP port number used here.
ipaddress - Specify IP address for the host.
<ipaddr> - Enter the IP address used for the configuration here.
<ipv6addr> - Enter the IPv6 address used for the configuration here.
state - The syslog protocol is used for the transmission of event notification messages across
networks to a host. The option enables or disables the host to receive such messages.
enable - Specify that the host to receive such messages will be enabled.
disable - Specify that the host to receive such messages will be disabled.
Restrictions
Only Administrators and Operators can issue this command.
Example
To configure the syslog host configuration:
To Next Page
Loading...
