D-Link DGS-3000 - Page 822

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
818
src_file - Specify the path name and file name of the FTP server. It can be a relative path
name or an absolute path name. If path name is not specified, it refers to the TFTP server
path. The maximum length is 64 characters.
<path_filename 64> - Enter the path name and file name of the FTP server. It can be a
relative path name or an absolute path name. If path name is not specified, it refers to
the TFTP server path. The maximum length is 64 characters.
dest_file - (Optional) Specify an absolute path name on the device. If path name is not
specified, it refers to the boot-up configuration file.
<pathname 64> - Enter an absolute path name on the device.
Restrictions
Only Administrator-level users can issue this command.
Example
To download runtime firmware from a TFTP server:
DGS-3000-26TC:admin#download firmware_fromTFTP 10.0.0.66 src_file runtime.had
dest_file runtime.had
Command: download firmware_fromTFTP 10.0.0.66 src_file runtime.had dest_file
runtime.had
Connecting to server................... Done.
Download firmware...................... Done. Do not power off!
Please wait, programming flash......... Done.
DGS-3000-26TC:admin#
upload 86-2
Description
This command is used to upload the firmware, configuration file, system log, or attack log to the
TFTP server.
Format
upload [cfg_toTFTP {[<ipaddr> | <ipv6addr> | <domain_name 255>] dest_file
<path_filename 64> {src_file <pathname 64>} {[include | exclude | begin] <filter_string 80>
{<filter_string 80> {<filter_string 80>}} {[include | exclude | begin ] <filter_string 80>
{<filter_string 80> {<filter_string 80>}} {[include | exclude | begin ] <filter_string 80>
{<filter_string 80> {<filter_string 80>}}}}}} | log_toTFTP{[<ipaddr> | <ipv6addr> |
<domain_name 255>] dest_file <path_filename 64>} | attack_log_toTFTP {[<ipaddr> |
<ipv6addr> | <domain_name 255>] dest_file <path_filename 64>} | firmware_toTFTP
{[<ipaddr> | <ipv6addr> | <domain_name 255>] dest_file <path_filename 64> {src_file
<path_filename 64>}}]
Parameters
cfg_toTFTP - Used to upload a configuration file from the Switch to the TFTP server.
<ipaddr> - (Optional) Enter the IP address of the TFTP server.
<ipv6addr> - (Optional) Enter the IPv6 address of the TFTP server.
<domain_name 255> - (Optional) Enter the domain name of the TFTP server here. This
name can be up to 255 characters long.