DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
836
runs out, port will be shutdown forever. The parameter is not applicable if “drop” (mode) is
specified for the “action” parameter.
<min 0> - Enter 0 to disable the forever state, meaning that the port will not enter the
shutdown forever state.
<min 3-30> - Enter the countdown timer value here. This value must be between 3 and 30.
disable – Specify that the countdown timer will be disabled.
time_interval - The sampling interval of received packet counts. The possible value will be m-n
seconds. The parameter is not applicable if “drop” (mode) is specified for the “action”
parameter.
<sec 5-600> - Enter the time interval value here. This value must be between 5 and 600.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the parameters so that the traffic control status is enabled on ports 1-12:
DGS-3000-26TC:admin#config traffic control 1-12 broadcast enable action
shutdown threshold 1 countdown 5 time_interval 10
Command: config traffic control 1-12 broadcast enable action shutdown threshold
1 countdown 5 time_interval 10
Success.
config traffic trap 89-2
Description
This command is used to configure trap modes.
• Occurred Mode: This trap is sent when a packet storm is detected by the packet storm
mechanism.
• Cleared Mode: This trap is sent when the packet storm is cleared by the packet storm
mechanism.
Format
config traffic trap [none | storm_occurred | storm_cleared | both]
Parameters
none - No trap state is specified for storm control.
storm_occurred - Occurred mode is enabled and cleared mode is disabled.
storm_cleared - Occurred mode is disabled and cleared mode is enabled.
both - Both occurred and cleared modes are enabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
To Next Page
Loading...
