DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
856
Parameters
<int 0-7> - Enter the priotity of the voice VLAN. This value must be between 0 and 7. The default
priority is 5.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To set the priority of the voice VLAN to be 6:
DGS-3000-26TC:admin#config voice_vlan priority 6
Command: config voice_vlan priority 6
Success.
config voice_vlan oui 94-4
Description
This command is used to configure the user-defined voice traffic’s OUI. The OUI is used to identify
the voice traffic. There are a number of pre-defined OUIs. The user can further define the user-
defined OUIs if needed.The user-defined OUI cannot be the same as the pre-defined OUI.
The following are the pre-defined voice traffic’s OUI:
OUI Vendor Mnemonic Name
00:E0:BB 3COM. 3com
00:03:6B Cisco cisco
00:E0:75 Veritel veritel
00:D0:1E Pingtel pingtel
00:01:E3 Siemens siemens
00:60:B9 NEC/ Philips nec&philips
00:0F:E2 Huawei-3COM huawei&3com
00:09:6E Avaya avaya
Format
config voice_vlan oui [add | delete] <macaddr> <macmask> {description <desc 32>}
Parameters
add - Adds a user-defined OUI of a voice device vendor.
delete - Delets a user-defined OUI of a voice device vendor.
<macaddr> - Enter the user-defined OUI MAC address.
<macmask> - Enter the user-defined OUI MAC address mask.
To Next Page
Loading...
