DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
859
DGS-3000-26TC:admin#config voice_vlan aging_time 60
Command: config voice_vlan aging_time 60
Success.
config voice_vlan log state 94-7
Description
This command is used to configure the log state for voice VLAN. If there is a new voice device
detected/or a port joins/leaves the voice VLAN dynamically, and the log is enabled, a log will be
triggered.
Format
config voice_vlan log state [enable | disable]
Parameters
enable - Specify that the sending of a voice VLAN log will be enabled.
disable - Specify that the sending of a voice VLAN log will be disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable the log state for voice VLAN:
DGS-3000-26TC:admin#config voice_vlan log state enable
Command: config voice_vlan log state enable
Success.
show voice_vlan 94-8
Description
This command is used to show the voice VLAN global information.
Format
show voice_vlan
To Next Page