D-Link DGS-3000 - Page 9

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
5
DGS-3000-26TC:admin#show
Command: show
Next possible completions:
802.1p 802.1x aaa access_profile
account accounting acct_client address_binding
arp_spoofing_prevention arpentry attack_log
auth_client auth_diagnostics auth_session_statistics
auth_statistics authen authen_enable authen_login
authen_policy authentication authorization autoconfig
bandwidth_control boot_file bpdu_protection cfm
command command_history community_encryption
config control_pkt cpu cpu_filter
current_config ddm device_status dhcp
dhcp_local_relay dhcp_relay dhcp_server dhcpv6
dhcpv6_local_relay dhcpv6_relay dhcpv6_server
dos_prevention dot1v_protocol_group dscp
duld eee environment erps
error ethernet_oam external_alarm fdb
filter flow_meter gratuitous_arp greeting_message
gvrp historical_counter
historical_utilization host_name igmp
igmp_snooping ipif ipif_ipv6_link_local_auto
iproute ipv6 ipv6route jumbo_frame
jwac l2protocol_tunnel lacp_port led
limited_multicast_addr link_aggregation lldp
lldp_med log log_save_timing
log_software_module loopdetect
mac_based_access_control mac_based_access_control_local
mac_based_vlan mac_notification max_mcast_group
mcast_filter_profile mirror mld_snooping
multicast multicast_fdb name_server
nd_spoofing_prevention nlb packet
password_recovery per_queue port port_security
port_security_entry port_vlan ports
power_saving pppoe private_vlan pvid
qinq radius rcp rmon
router_ports rspan safeguard_engine scheduling
scheduling_mechanism serial_port session
sim smtp snmp sntp
sred ssh ssl
storage_media_info stp sub_vlan
super_vlan switch syslog system_severity
tech_support terminal tftp time
time_range traffic traffic_segmentation
trap trusted_host utilization vlan
vlan_translation vlan_trunk voice_vlan wac
DGS-3000-26TC:admin#
In the above example, all of the possible next parameters for the show command are displayed. At
the next command prompt, the up arrow was used to re-enter the show command, followed by the
account parameter. The CLI then displays the user accounts configured on the Switch.