Dynon Avionics SkyView Classic - Skyview HDX Display Setup; Layout

SkyView Display Installation and Configuration
SkyView System Installation Guide - Revision AA 4-41
 REQUIRED: The relevant page is always shown on this display. This is always
shown on this display. The relevant page button under the SCREEN menu is
not available.
 ALLOWED (SAVE STATE): This display remembers whether the relevant page
was being shown across power cycles. The relevant SCREEN button turns that
page on and off on this display.
 ALLOWED (NOT SHOWN AT BOOT): The relevant page is never on at boot.
The relevant page button under the SCREEN menu turns that page on and off
on this display.
 ALLOWED (SHOWN AT BOOT): The relevant page is always on at boot. The
relevant page button under the SCREEN menu turns that page on and off on
this display.
 NOT ALLOWED: The relevant page cannot be shown on this display. The
relevant SCREEN button is not available.
o VIDEO PAGE: You can control whether the VIDEO PAGE is:
 ALLOWED (NOT SHOWN AT BOOT): The VIDEO PAGE is never on at boot. The
VIDEO button under the TOOLS menu turns that page on and off on this
display.
 NOT ALLOWED: The VIDEO PAGE cannot be shown on this display. The VIDEO
button under the TOOLS menu is not shown.
 REVERSION MODE CONFIGURATION – When only one display is powered on in a multiple
display configuration, the layout picked here is forcibly displayed. This behavior applies
equally whether all but one display in your system has failed or if you turn on one SkyView
display before all others (as some SkyView pilots do to see engine instruments before
engine start). This setting applies to all displays in the system, regardless of which display
the settings are changed on.
o DISABLED: Reversion Mode is disabled. The layout that was set on any display
remains the same whether or not it is the only display powered on in a multi-display
system.
 PFD 40% / EMS / MAP 40%
 PFD 50% / MAP 50%
 PFD 50% / EMS 50%
 PFD 80% / EMS 20%
 PFD 100%
SkyView HDX Display Setup / Layout
For SkyView HDX, setup / layout of the display / screen is performed as an operational function
by pushing the DISPLAY key in the Main Menu.
Reference for the SkyView HDX Pilot’s User Guide for more detail about setting up your
SkyView HDX display’s layout.