Appendix A: Maintenance and Troubleshooting
SkyView System Installation Guide - Revision AA 21-7
performance of compass and AOA calibration. If these do not seem to work as well as
they previously did, redo those calibrations.
If the ADAHRS is not the same serial number as the one you returned for repair, all setup and
calibration steps should be performed because this ADAHRS is being installed for the first time.
Autopilot Servos
1. Reinstall the servo in the aircraft.
2. Reconnect all harnesses and connections as originally installed.
3. Power up the entire SkyView System (all displays, modules, servos, etc.).
4. From any display in the aircraft, reconfigure SkyView Network under SETUP MENU >
SYSTEM SETUP > SKYVIEW NETWORK SETUP > CONFIGURE…
5. Confirm all SkyView Network components are found, including the reinstalled servo.
6. Assuming the Autopilot was previously set up and working correctly, you only need to
recalibrate the servos by going to SETUP MENU > HARDWARE CALIBRATION > AP SERVO
CALIBRATION > CALIBRATION and following the on-screen instructions.
All other SkyView Network Components
1. Reinstall the SkyView Network component in the aircraft.
2. Reconnect all harnesses and connections as originally installed.
3. Power up the entire SkyView System (all displays, modules, servos, etc.).
4. From any display in the aircraft, reconfigure SkyView Network under SETUP MENU >
SYSTEM SETUP > SKYVIEW NETWORK SETUP > CONFIGURE…
5. No further action should be required.
Operational Status
SkyView displays give users access to vital operational information in the Display Hardware
Information Page (SETUP MENU > LOCAL DISPLAY SETUP > DISPLAY HARDWARE
INFORMATION). Note that the information in this menu may be useful during troubleshooting.
The information here cannot be edited on this screen; however, some parameters are editable
by the user on other screens.
This menu contains the following information:
Display serial number
Software version
Display input voltage
SV-BAT-320 charge state
Operational state of the internal battery management circuitry
Operational state of the internal voltage rails
Screen brightness level
Local light sensor output
External light sensor output
Brightness level output
Contact input status
To Next Page
Loading...
