Basic SkyView Display Operation
3-6 SkyView System Installation Guide - Revision AA
When in a list of menu items, to move up and down the menu, simply rotate the knob clockwise
to move down the menu, and counter-clockwise to move up the menu. When the desired menu
is highlighted, push the knob (pushbutton) to enter the desired menu.
Menu Navigation
After the display turns on, you will see a screen similar to the one in Figure 10. This guide refers
to the label bar at the bottom of the screen as the Main Menu.
Throughout this guide, the “>” character is used to indicate a sequence of menu selections or
other actions you would take as you navigate the menu system. Menu selections which are
followed by “…” indicate full-screen wizard interfaces which guide you through the appropriate
steps. These wizard interfaces are not described in detail in this guide, as the on-screen
instructions provide adequate information.
SkyView menus follow this structure: SETUP MENU > MENU > ... > MENU > PAGE or WIZARD.
The setup menus (In Flight Setup or Setup) are the root of most menu navigation. Each nested
menu is more specific than the previous one and there is no set limit for the number of nested
menus before reaching a page. A page or wizard is at the end of the chain and it is where the
user can perform a specific action such as change a specific setting, configure a SkyView
network, or set up the layout of the onscreen engine gauges. Wizards employ easy-to-follow
onscreen instructions.
For example, SETUP MENU > SYSTEM SETUP > MEASUREMENT UNITS > BAROMETER indicates
entering the SETUP MENU, then selecting SYSTEM SETUP, then selecting MEASUREMENT
UNITS, and then entering the BAROMETER Menu to select INHG, MBAR, or MMHG.
Table 9 is a summary of menu navigation.
To Next Page
Loading...
