Appendix J: Checklists
SkyView System Installation Guide - Revision AA 30-5
CHKLST4.TITLE, RUN-UP & PRE-TAKEOFF
CHKLST4.LINE1,
CHKLST4.LINE2, BUILD YOUR CHECKLIST HERE
# …
CHKLST21.TITLE, MISC: TRANSPONDER CODES
CHKLST21.LINE1,
CHKLST21.LINE2, VFR - 1200 (USA)
CHKLST21.LINE3, VFR - 7000 (Europe)
CHKLST21.LINE4, Hijack – 7500
CHKLST21.LINE5, Radio Fail – 7600
CHKLST21.LINE6, Emergency - 7700
Example Checklist Formatting Notes:
Comment lines (not displayed as a Checklist item) begin with #. Example:
# This line in a checklist file will not be displayed in a
checklist.
Checklist numbering starts with 0; the first Checklist displayed is CHKLST0.
For additional Checklists, increment the name CHKLIST in each section from 0. Example:
CHKLST0
CHKLST1
…
CHKLST10
CHKLIST11
(etc.)
Each Checklist requires a title line in this format:
CHKLST(section number).TITLE, (title). Example:
CHKLST0.TITLE, PRE-FLIGHT
Each Checklist can have any number of Checklist items (including none), but each item must be
sequentially numbered, beginning from 1, in this format:
CHKLST(section number).LINE(checklist item), (title). Example:
CHKLST0.LINE1,
CHKLST0.LINE2, BUILD YOUR CHECKLIST HERE
Each Checklist Name and Checklist Item will only display 31 characters for a 40% Page, and 40
characters on a 50% page. Characters in excess of these lengths will not be wrapped and will
simply not appear.
# LINES ARE 31 CHARACTERS LONG ON A SKYVIEW 40 PERCENT PAGE
# LINES WITH MORE CHARACTERS THAN ABOVE ARE NOT WRAPPED AND WILL
NOT SHOW
CHKLST0.TITLE, 1234567890123456789012345678901
CHKLST0.LINE1, 1234567890123456789012345678901