Dynon Avionics SkyView Classic - Joystick and Button Operation

Basic SkyView Display Operation
SkyView System Installation Guide - Revision AA 3-3
Each SkyView display has an integrated light sensor in the bezel. This light sensor can be used
for automatic backlight level management. Reference the Display Setup Section of this guide for
instructions on how to configure the display for automatic backlight level management.
Joystick and Button Operation
Joysticks and buttons are used for various functions including powering the unit on and off,
entering and navigating menus, and adjusting values.
Operation Basics
SkyView Classic and SkyView SE joysticks can be turned and moved. Specific joystick behavior is
addressed in subsequent sections of this guide when necessary.
Figure 11 – SkyView Classic and SkyView SE Joystick Turn (left) and Movement (right) Directions
(Pushbutton Function Not Shown)