Basic SkyView Display Operation
SkyView System Installation Guide - Revision AA 3-13
DISPLAY COM IN TOP BAR – Selects whether, or not, frequencies, PTT status, etc. from the
COM radio (selected in PRIMARY COM, above) is displayed.
DATA LOG SETUP – Enter this page to configure the recording frequency of SkyView’s
internal data logging feature, or to clear recorded data. See the User Data Logs Appendix for
further information about user data logs.
LOCAL DISPLAY SETUP Menu
This menu contains menus and pages related to the individual SkyView display on which this
menu is displayed. These settings can be different on one display from another display.
INSTALLED DATABASES – Shows the various databases that are installed on this display and
their respective versions.
DISPLAY HARDWARE INFORMATION – Shows important hardware status information such
as the “Edition” of your SkyView display (SKYVIEW, or SKYVIEW SE), serial number of your
display and the voltage of the attached SV-BAT-320. Reference the Returning SkyView
Components to Service after Repair Section of this guide for more information about the
Display Hardware Information Page.
BRIGHTNESS SETUP – Choose between manual, automatic, or external screen backlight
control. Manual screen backlight control is managed by the user in the DIM Menu with the
DEC-, INC+, and FULL buttons. Automatic screen backlight control is managed by a default
dimming profile in the display. A compatible external control signal is required for external
backlight control. Reference the Brightness Setup Section for more information.
TOP BAR SETUP – Configure the top bar on the SkyView display's screen.
GPS FIX STATUS – Shows fix quality information for the GPS source that is being used as the
active position source for SkyView’s moving map and synthetic vision. Note that this does
not show information about other GPS sources that may be available for HSI and backup
position use.
BATTERY BACKUP (SV-BAT-320) STATUS – Shows the status of automated tests of the SV-
BAT-320.
LICENSE – This page shows the status of Software products that can be purchased and
licensed to add features to SkyView. This page is also the place where license codes can be
redeemed to activate features on your SkyView System.
DISPLAY LANGUAGE – ENGLISH (ENGLISH) | (alternate language). If a language pack is
installed, you can configure this display to display the alternate language. If a language pack
has not been loaded, this option will be grayed out and not accessible. Language packs can
be downloaded from http://downloads.dynonavionics.com.
To Next Page
Loading...
