Appendix J: Checklists
SkyView System Installation Guide - Revision AA 30-9
home, so this is best done using a laptop computer in the aircraft, so you can edit, export, and
test rapidly on your SkyView display.
Once a Checklist is loaded, there is no way to delete the current Checklist. The closest thing to a
“delete Checklists” function is to load an empty file (no text in it) with a filename such as
blankchecklist.txt. This will have the effect of displaying a blank page when the CHECKLIST
button is pressed.
Displaying Your Checklist on your SkyView Display
Until a Checklist file is loaded into your SkyView system, the CHECKLIST button will
not appear in the TOOLS menu. A default / example Checklist is not installed in
new SkyView displays, nor is a default / example Checklist automatically installed
into a SkyView display as part of updating your SkyView system to Software v14.0.
To access your Checklist on a SkyView display, from the main menu, go to the TOOLS menu and
push the CHECKLIST button. The Checklist will continue to be displayed until the CHECKLIST
button is pressed again (the CHECKLIST button “toggles” the display of your Checklist On and
Off).
Your Checklist will be displayed on the SkyView display in a 40% window or 50% window per
the following conditions:
The Checklist will not obscure the PFD
If the display is set to display 100% PFD, MAP, or EMS, the original page will be resized
to 50% and the Checklist will be displayed at 50%.
o If the Checklist displays at 40% on a 100% page, temporarily enable another
page, select the 50% / 50% layout, then disable the temporary page. The
Checklist should now correctly display at 50%.
If the display is set to display 60% PFD / 40% MAP or EMS, the MAP or PFD (40% page)
will be replaced with the Checklist (displayed at 40%).
If the display is set to display MAP and EMS (any % of either), the EMS page will be
resized to 50% and the Checklist will be displayed at 50%.
To Next Page
Loading...
