EasyManua.ls Logo

Dynon Avionics SkyView Classic - 8 SV-GPS-250;2020 GPS Receiver Installation and Configuration

Default Icon
573 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SkyView System Installation Guide - Revision AA 8-1
8. SV-GPS-250/2020 GPS Receiver Installation and Configuration
SkyView SE supports only one unit, either an SV-GPS-250 or an SV-GPS-2020, as a
GPS position source. The installation of a secondary GPS position source is not
supported in SkyView SE. Thus, instructions for installation and configuration of a
secondary GPS position source in this section are not applicable to a SkyView SE
system. If your aircraft requires the use of a secondary GPS position source,
SkyView SE is not recommended.
This section explains the installation and configuration of the Dynon Avionics SV-GPS-250 GPS
Receiver and SV-GPS-2020 GPS Antenna/Receiver Module (High Integrity GPS). After reading
this section, you should be able to determine how to prepare the installation location, mount
the unit, connect the unit to a SkyView display(s), and configure it in the SkyView display.
Information specific to either the SV-GPS-250, or specific to the SV-GPS-2020 references the
individual unit. Information that is applicable to either unit is referenced by SV-GPS-
250/2020.
The SV-GPS-250 was part of the introduction of the SkyView system in December, 2009. From
then, through December, 2015, the SV-GPS-250 was the only GPS receiver available from Dynon
Avionics. Thus, any aircraft built prior to January, 2016 that has “all Dynon Avionics” panel likely
includes an SV-GPS-250. The SV-GPS-2020 was released for sale beginning January, 2016.
As of January, 2016, the intended use for the SV-GPS-250 in a SkyView system is:
US pilots secondary GPS receiver (SV-GPS-2020 is primary) (not supported in SkyView
SE),
US pilots SV-GPS-250 was installed prior to the availability of the SV-GPS-2020 and are
waiting until closer to 2020 to retrofit / add an SV-GPS-2020, or
Non-US pilots whose aviation authorities do not require a high-integrity GPS position
source for Mode-S transponder transmission primary or secondary GPS receiver.
The SV-GPS-250 and SV-GPS-2020 are self-contained GPS receivers intended for use with the
Dynon Avionics SkyView system and the Advanced Flight Systems (AFS) AF-5000 system. The
SV-GPS-2020 provides “high integrity” GPS data to the SkyView system that is required by the
FAA 2020 ADS-B Out mandate. The SV-GPS-250 does not provide “high integrity” GPS data to
the SkyView system that is required by the FAA 2020 ADS-B Out mandate. Unlike similar-looking
GPS units, the electronics of the GPS receiver are contained within the unit there is no
Figure 89 SV-GPS-250
Figure 90 SV-GPS-2020

Table of Contents

Related product manuals