SV-COM-C25 Installation and Configuration
SkyView System Installation Guide - Revision AA 16-17
Avoid kinking the cable even temporarily during installation.
Secure the cable so that it cannot interfere with other systems.
SkyView System Settings for SV-COM-C25
Network Setup
As with all other SkyView Network devices, the SV-COM-C25 must be configured into the
SkyView Network:
Go to SETUP MENU > SYSTEM SETUP > SKYVIEW NETWORK SETUP > CONFIGURE > (right
click) > DETECT (button).
The SV-COM-C25 will be listed as SV-COM-PANEL.
FINISH (button) > EXIT (button)
COM RADIO Setup
To adjust Squelch, Sidetone, and Microphone Gain, go to SETUP MENU > COM RADIO SETUP:
> SQUELCH LEVEL – Adjust squelch level so that the audio is heard during transmissions, and
muted when transmissions are not present.
> SIDETONE VOLUME – Adjust for your personal preference of how much microphone audio is
heard in the headset when transmitting.
The SV-COM-425’s MIC GAIN setting is applied to the microphone audio signal
after any microphone gain provided by a “powered” headset (especially higher-
end noise-cancelling headsets). It may be necessary to interactively adjust the
headset’s microphone gain and the SV-COM-425 MIC GAIN setting to result in
acceptable audio quality / audio level being transmitted.
For example, an “unpowered” (conventional) headset may require a MIC GAIN
setting of 70 for acceptable audio quality / audio level being transmitted. A noise-
cancelling headset with a microphone adjustment may require a MIC GAIN setting
of 30 for acceptable audio quality / audio level being transmitted.
To Next Page
Loading...
