Dynon Avionics SkyView Classic - EMS SETUP Menu; MAP SETUP Menu

Basic SkyView Display Operation
SkyView System Installation Guide - Revision AA 3-15
 ALWAYS NORMAL – The NORMAL view of the horizon on the PFD will always
be displayed. The WIDE ON / OFF button is not present in the PFD > MODE
menu.
 ALWAYS WIDE – The WIDE view of the horizon on the PFD will always be
displayed. The WIDE ON / OFF button is not present in the PFD > MODE
menu.
 SELECTABLE – The WIDE ON / OFF button is present in the PFD > MODE
menu, allowing either WIDE or NORMAL views of the horizon on the PFD.
 BARO MISMATCH WARNING – Enables / disables a warning message when the current
SkyView BARO setting and nearest valid ADS-B METARS report barometric pressure are
significantly different.
EMS SETUP Menu
This menu is not accessible if a SV-EMS-220/221 is not installed. Reference the
Autopilot Servo Calibration and Test Procedures Section of this guide for more
information.
This menu contains menus and pages related to Engine Monitoring System page and data
source (EMS module).
 ENGINE INFORMATION – Set important information regarding the engine in your aircraft
such as engine type and horsepower. The user-entered information here is used to calculate
quantities such as % power and special operating limitations.
 SENSOR INPUT MAPPING... – This wizard configures the individual multipurpose pins of the
SV-EMS-220/221(s) to specific engine and environmental sensors. Reference the EMS
Sensor Input Mapping Section of this guide for instructions on how to navigate and use this
menu to map sensors.
 SCREEN LAYOUT EDITOR – This wizard configures the placement and style of the onscreen
EMS gauges on EMS pages. Reference the EMS Screen Layout Editor Section of this guide for
instructions on how to use this wizard.
 SENSOR SETUP – Configures the ranges, alarm conditions, and graphical display properties
of sensors. Reference the EMS Sensor Setting Section of this guide for more information
regarding sensor setup.
 DUAL EMS SETUP – If a second SV-EMS-220/221 is installed, configures how the pins
(inputs) of the second SV-EMS-220/221 are used.
(Note: Support for dual SV-EMS-220/221 modules is supported only in SkyView Classic; this
feature is not available in SkyView SE or SkyView HDX (as of Software v15.0).
 SENSOR DEBUG DATA – Displays diagnostic / troubleshooting data for engine sensors. Also
displays the version of the EMS Sensor Definitions file loaded on this SkyView display. See
Appendix H: Sensor Debug Data for how to interpret the information displayed on this page.
MAP SETUP Menu
This menu contains menus and pages related to MAP page and data sources.