1. Insert the USB flash drive into one of the display’s USB sockets.
2. Go to the Export Settings Wizard (SETUP MENU > SYSTEM SOFTWARE > EXPORT
SETTINGS…).
3. Create a file name for the settings file.
4. Save the settings file onto the flash drive by pressing EXPORT or press CANCEL to return to
the SYSTEM SOFTWARE menu.
How to Load and Delete Files
1. Download file from http://downloads.dynonavionics.com such as terrain or EMS files or use
another source for the SkyView file.
2. Copy the file onto your USB flash drive. The file must be in the root directory of the drive in
order to be recognizable by the display.
3. Insert the USB flash drive into one of the display’s USB sockets.
4. Go to the Load Files Wizard (SETUP MENU > SYSTEM SOFTWARE > LOAD FILES…).
5. Select a file and press:
a. LOAD to load the file onto the system.
b. CANCEL to return to the SYSTEM SOFTWARE menu.
c. REMOVE to delete the file from the USB flash drive.
How to Export Data Logs and Waypoints
EXPORT DATA LOGS
Data logging, and how to export datalogs is discussed in depth in Appendix F: User Data Logs.
EXPORT USER WAYPOINTS
This option exports all of the User Waypoints that are currently stored in your SkyView system.
EXPORT DYNON DIAGNOSTIC FILE
This specialized data log can only be interpreted by Dynon Avionics Engineers; there is no data
in it that can be interpreted by SkyView pilots. Dynon Avionics Technical Support may request
this log in the course of troubleshooting, especially for issues related to AP performance. Note
that this log is very big – over 500 MB – and takes minutes to save to a USB flash drive. Unless
directed to export this log by Dynon Avionics, there is no reason to do so. This file is too large to
send in an email message.
If you have more than one SkyView display in your system, you may be requested to save the
Dynon Avionics Diagnostic File from each of your SkyView displays as each display can
sometimes contain different diagnostic data. If you save the Dynon Avionics Diagnostic File
To Next Page
Loading...
