Basic SkyView Display Operation
3-10 SkyView System Installation Guide - Revision AA
Note that this menu occupies only half of the screen and that all of the links in the In Flight
Setup Menu are accessible via the SETUP MENU.
SETUP MENU
This menu contains links to system configuration options:
SYSTEM EVENT
SYSTEM SOFTWARE
SYSTEM SETUP
LOCAL DISPLAY SETUP
PFD SETUP
EMS SETUP
MAP SETUP (Not supported in SkyView SE)
AUTOPILOT SETUP
TRANSPONDER SETUP
TRAFFIC SETUP (Not supported in SkyView SE)
VP-X SETUP (Not supported in SkyView SE or SkyView HDX [as of Software v15.0])
ACM SETUP (Not supported in SkyView SE)
ADS-B STATUS (Not supported in SkyView SE)
COM RADIO SETUP
HARDWARE CALIBRATION
Note that this menu occupies the entire screen. The menus above have menus of their own. The
information in this section contains information on the purposes of each of the above menus as
well as a list of each menu's respective menus and their functions.
Pages and wizards that require users to do something have explicit onscreen
instructions. Most actions are simple enough and onscreen instructions are more
than adequate. In these cases, explicit instructions are not contained in this guide.
In cases where onscreen instructions are not present, instructions are included in
this guide.
The menu options descriptions in this section are intended to be introductory /
overview, not comprehensive. Comprehensive explanations of menu options can be
found onscreen, in the SkyView system, in the installation instructions in the
specific section of this manual for each subsystem, such as SV-EMS-220/221 or SV-
XPNDR-261/262.
SYSTEM EVENT Menu
The SYSTEM EVENT menu will only appear if the SkyView display detects that a “system event”
has occurred on (one of your) SkyView display(s).
To Next Page
Loading...
