Dynon Avionics SkyView Classic - Location Requirements for Skyview Displays

SkyView Display Installation and Configuration
4-2 SkyView System Installation Guide - Revision AA
Physical Installation
Display
Panel Cutout
Bezel Outline
SV-D600
6.97” x 5.35”
(177.038mm x 135.890mm)
7.636” x 5.512”
(193.954mm x 140.005mm)
SV-D700
SV-D900
9.68” x 6.90”
(245.872mm x 175.260mm)
10.320” x 7.064”
(262.128mm x 179.426mm)
SV-D1000
SV-D1000T
SV-HDX800
6.97” x 5.35”
(177.04mm x 135.89mm)
7.64” x 5.59”
(194.0 mm x 142.0mm)
SV-HDX1100
9.68” x 6.28”
(245.87mm x 159.50mm)
20.31” x 7.07”
(262mm x 179.5mm)
Table 11 – SkyView Displays Installation Dimensions Quick Overview
If you are converting your panel from a Dynon Avionics EFIS-D100, EMS-D120, or
FlightDEK-D180, note that the SV-D600, SV-D700, and SV-HDX800 displays have a
slightly larger panel cutout than those products and the existing panel cutout for
those products must be slightly enlarged.
Location Requirements for SkyView Displays
Observe the following guidelines when choosing a location for a SkyView display:
 SkyView displays require about 2.4” (61mm) of free space behind the panel, depending on
mounting surface thickness.
 Consider the ease, or difficulty of disconnecting multiple connectors when removing a SkyView
display from the panel. Plan for either:
o Providing sufficient slack in the cables so that the SkyView display can be removed
from the panel and then the cables disconnected, or…
o Disconnecting (and reconnecting) the cables from behind the panel prior to
removing the SkyView display from the panel.
 The SkyView Display Harness (SV-HARNESS-D37) extends about 3” (76mm) from the back of the
display.
 Add a 1.0” (25.4 mm), minimum, beyond the physically required volume for the SkyView
display’s heat sinks and fans to operate.
 Avoid placing the display near heater vents or any source of extremely hot air.
While SkyView displays do not (normally) require a forced cooling air, if the aircraft
is to be operated in hot climates, the builder should ensure that the stated
operating temperature range for SkyView displays is not exceeded.
 The display should be easily viewable without any obstructions.
 SkyView Displays have no internal inertial sensors and do not need to be mounted in the same
orientation as the ADAHRS or other modules.