Document number changed to 101320-025, Revision Z
New products:
o SkyView SV-HDX800 display
o SkyView SV-HDX1100 display
o ADS-B (UAT) Antenna – Rod type (978 MHz)
o Transponder antenna – Rod type (1090 MHz)
o SV-MAP-270 included with new SkyView displays and SkyView HDX
(Section 6)
New features:
o Weight and Balance (Setup)
o Maintenance Log (Setup)
o Ability to change label “CHT” to “CLNT”
o Ability to change aural message “Cylinder Head Temperature” to
“Coolant Temperature”.
Software changes in SkyView Software v15.0.0, released 2016-10-18.
o SkyView SV-HDX800 display (new product)
o SkyView SV-HDX1100 display (new product)
o SV-BAT-320 charging algorithm improved to be able to charge units
that are in protection mode.
Documentation improved in this revision:
o Section 4 – Added connection and configuration instructions for GNC
255 COM/NAV radio.
o Section 5 – Corrected incorrect references to Figures on different
AOA/Pitot Probes
o Section 7 – Updated references to use of dual SV-EMS-220/221
modules to monitor large engines or dual engines is only supported in
SkyView Classic (not SkyView SE or SkyView HDX [as of Software
v15.0])
o Section 7 – Added mention of SV-NET-SPL for use with dual SV-EMS-
220/221 installations.
o Section 7 – Added lists of all available and recommended Dynon
Avionics engine sensor kits.
o Section 11 – Added detail about the permissible use of SV-XPNDR-262
after 2020 (outside Class B and Class C airspaces)
o Section 13 – Explanation that to monitor operation of VPX, one
display must include an SV-BAT-320 or be powered independently of
the VP-X.
o Section 16 – Added alternate method for adjusting Microphone Gain
of SV-COM-C25.
o 579 pages
To Next Page
Loading...
