Dynon Avionics SkyView Classic - Troubleshooting

Appendix A: Maintenance and Troubleshooting
21-12 SkyView System Installation Guide - Revision AA
the USA, call 1-800-8-BATTERY or see the Call 2 Recycle website at
http://www.rbrc.org.
Troubleshooting
The Display Hardware Information Page (SETUP MENU > LOCAL DISPLAY SETUP > DISPLAY
HARDWARE INFORMATION) can be a valuable resource when troubleshooting SkyView and is
described in the previous section.
If the suggestions below do not help, or your issue is not listed below, please
contact Dynon Avionics Technical Support (contact information at the beginning of
this manual).
Network Configuration Does Not Work or SkyView Network Module Is Not Working
Properly
If you try to configure a SkyView network and it does not work, try the following:
 Check network wiring and try again. There may be a short or an open somewhere.
 Unplug network modules one by one and try again. It is possible that one of the modules
could cause the network to stop functioning.
 Try again.
 For modules such as the SV-ADAHRS-200/201, the SV-EMS-220/221, and SV-ARINC-429,
observe the red LED light near the SkyView Network connector:
o Flashing Fast: The module is operating normally and is configured and
communicating on a SkyView Network.
o Flashing Slowly: The module is operating normally, but is not active on SkyView
Network.
o Off: The module is not receiving power (from a SkyView Network / Display)
o On Solid - the module is receiving power, but is not operating normally.